Ikan Wireless Microphone System & One Receiver (CoMica CVM-WM100)

Features
• 100m maximum transmission distance
• 48 channels to choose from between 520-534.1MHz
• Less than .5% audio distortion
• Receiver and transmitter run on 2 AA batteries (not included)
• 3.5mm input/output ports with 3-pin XLR adapter included
• Mounts with included belt clips or via 1/4-20 mounting points on TX/RX bodies
• LCD screen includes signal strength and battery life indicators
The CVM-WM100 is a wireless lavalier microphone kit from CoMica. This kit contains one transmitter, one receiver, one lavalier microphone with a 3.5mm connector, a soft case, and accessories like a wind muff, 3.5mm-XLR adapter, and cold shoe mounts for the transmitter and receiver.
 
To use this kit, install two AA batteries in both the transmitter and receiver, then turn them on. Select one of 48 available channels, and monitor for signal interference. If there is a lot of interference on one channel, scan through others until you find a clean, noise-free channel to use. Both the transmitter and receiver can be worn on the belt, mounted to the included cold shoe mounts, or attached to an accessory arm via the 1/4-20 mounting point on each unit.
 
When a solid signal is established, connect the lavalier mic and, if you desire, a secondary sound input device to the transmitter. Plug the receiver into the camera, recorder, or speaker of your choice (for speakers, make sure they have sufficient amplification to adequately handle the signal). Test the levels by taking test-audio, and get to recording! When recording is finished, the entire kit can be placed into the included soft carrying case for storage and transport.

Delivery Content
1x Lavalier Transmitters
1x Receiver
1x 3.5mm Audio Input Cable
1x 3.5mm-3.5mm Audio Output Cable
1x 3.5mm-XLR Audio Output Cable
3x Belt Clip
1x Camera Mount
2x Wind Muff
1x USB Power Input Cable
1x Portable Bag
1x User Manual
1x Warranty Card

Technical Specifications

Antenna Type

Short Wave

Audio Distortion

< 0.5%

Battery Operation Time

~10 hrs. (standby)

Battery Type

2x AA Batteries per Receiver/Transmitter (not included)

Capacity mAh

3.7V 2000mAh per unit

Frequency Bands

Group A:520~548.5MHz Group B: 550~578.5MHz

Inputs

3.5mm

Outputs

3.5mm

Receiver Sensitivity

-95dBm

Sound Delay

< 20ms

Stray Radiation

<-60dBc

Transmission Power

10dBm/15dBm